1. Installation Instructions for Roofing a Beamed Structure
Step 1 – Use screws (see: Accessories Table) to attach the base connecting
profiles to the roof beams. Make sure that screws do not bend, tear or exert
excessive pressure on the profile.
Step 2 – Place the sheet on top of the base profile support edges, with
the side covered by the printed protective film facing upwards.
Step 3 – Slide the base under the sheet and attach it to the beam.
Step 4 – Place the side spacer profile (see: Accessories Table) onto the roof
beam and attach the cap to the base by hammering into place with a rubber mallet.
Steps 5 to 7 – Continue adding sequentially, a sheet (step 5),
a base connecting profile (step 6) and a cap (step 7) until reaching the end
of the building. After completing installation, remove all the printed protective
film from the sheets.
4. FILM REMOVAL:
The UV protected surface of YUEMEI sheet is covered at manufacture with a branded film. This should always be on the outside of the installation. A further plain film is applied to the inner surface. To install, the film should be peeled back about
When drilling YUEMEI polycarbonate sheet, use standard twist drills and carbide tipped drills. The sheet must be supported firmly underneath when drilling. Holes must not be drilled any less than